How to maintain the automatic bottle blowing machine?

Update:18-01-2021
Summary:

What is an automatic blowing machine? Are you as suspic […]

What is an automatic blowing machine? Are you as suspicious as I am? Maintenance and maintenance of automatic bottle blowing machine:
1. There are several situations that need to be checked if the feeding level is not feeding:
Whether there is no material in the hopper, if yes: need to add material quickly
No: Please check whether the control contactor of the hoist is energized. If it is energized, quickly check whether the motor is energized and loaded, because this situation is likely to be caused by the preform (embroid) stuck in the lift With, the easiest way at this time is to manually help improve.
If you check that the control contactor of the hoist is not energized, please check whether the preform detection electric eye and the reflector are not in the same straight line.
2. Feeding old card feeding tray: This situation is a more headache problem. From experience, if the length of the preform (blank) is longer and the weight is larger, then this phenomenon is relatively rare.
3. After the bottle is blown, it cannot be taken out of the mold.
First of all, you should open the mold, open and close the mold manually, if it is normal, run it in the dry running state, if it is also normal.
Please check your exhaust time setting. If the exhaust setting is normal and it fails as long as you blow the bottle each time, then it can be judged that the problem is with the exhaust valve. Please open the exhaust valve to check the condition of its spring and seal (this Another phenomenon of this failure is that the exhaust sound is relatively loud or there is a sound of dirty exhaust).
If you encounter a situation where many molds are normally produced and accidentally cannot open the mold, please check whether the clamping pin has a segmented screw in it. In addition, please check whether the clamping force is too large. If it is too large, you should follow Standard readjustment.
4. Bottles are always pinched: Whether the position of the manipulator is misplaced.
5. Two manipulators collide: In this case, the manipulator needs to be reset manually, which is caused by misalignment.