bangemachine.com
China Water Bottling Machine Suppliers Plastic Water Bottle Making Machine Manufacturers Español
    • Home
    • About Us
      • Company Profile
    • Products
      • PET Blow molding machine
      • Extruders
      • plastic bottle cap compression moulding machine
      • Preform Mould
      • Auxiliary equipment
    • Video Center
    • News
      • Company News
      • Industry News
    • Contact Us
Home / News / Industry News (Page 16)
News
  • Company News
  • Industry News

Contact Us

  • Tel: 0086(576)一84086527
  • Tel: 0086(576)一84035196
  • SKYPE: karlmould
  • Mob/Whatspp/Wechat:(0086)13645861625
  • Email: karl@bangemachine.com
  • Add:West mould city Huangyan Taizhou city Zhejiang China.
  • How often is the bottle blowing machine maintained? What are the precautions for maintenance? (2)

    14-09-2020

    1. When the bottle blowing machine is in operation, it is necessary to pay close attention to whether the machine has abnormal noises, to find out early, and to stop it in time and deal with it early. 2. In an emergency,...

  • What are the uncertain factors in the production of the bottle blowing machine? (1)

    21-09-2020

    The bottle blowing machine is used to blow plastic hollow products such as PP, PE, fruit milk beverage bottles, daily chemical bottles, sealant barrels, etc. The machine adopts microcomputer numerical control technology,...

  • What are the uncertain factors in the production of the bottle blowing machine? (2)

    28-09-2020

    1. In the production, the temperature control is not accurate or the temperature deviation is large, and the installation position of the temperature measurement point (thermocouple) is unreasonable, which causes the tem...

  • How to deal with the poor mold blown by the hollow bottle blowing machine?

    09-10-2020

    What should I do if the mold cannot be blown to form? First check the pressure of the blow molding machine? If the pressure is normal, check whether the exhaust structure of the mold is reasonable, and then adjust the te...

  • What are the reasons for the air leakage of the bottle blowing machine?

    19-10-2020

    1. The pressure of the sealing cylinder is enough. If the low pressure sealing cylinder is selected, the low pressure can be kept below 8 kg. Normal water bottles are no problem. But it also depends on the high-pressure ...

  • In what ways can the blowing machine's mechanism be innovative?

    26-10-2020

    Preform conveying mechanism: The unique preform mandrel conveying mechanism ensures that there is no risk of inversion of the preform during heating. High-speed operating mold clamping mechanism: This series of blow mold...

<<<...10...1415161718>
borgmolds.com
Home About Us Products Video Center News Contact US
Inquiry Now contact us

Copyright © Taizhou Huangyan Bangge Mould Factory All rights reserved. bottling machine manufacturers Web support by :HWAQ