Industry News - News

Home / News / Industry News (Page 5)

What are the reasons for the air leakage of the bottle blowing machine?
19-10-2020
1. The pressure of the sealing cylinder is enough. If the low pressure sealing cylinder is selected, the low pressure can be kept below 8 kg. Normal water bottles are no problem. But it also depends on the high-pressure ...
How to deal with the poor mold blown by the hollow bottle blowing machine?
09-10-2020
What should I do if the mold cannot be blown to form? First check the pressure of the blow molding machine? If the pressure is normal, check whether the exhaust structure of the mold is reasonable, and then adjust the te...
What are the uncertain factors in the production of the bottle blowing machine? (2)
28-09-2020
1. In the production, the temperature control is not accurate or the temperature deviation is large, and the installation position of the temperature measurement point (thermocouple) is unreasonable, which causes the tem...
What are the uncertain factors in the production of the bottle blowing machine? (1)
21-09-2020
The bottle blowing machine is used to blow plastic hollow products such as PP, PE, fruit milk beverage bottles, daily chemical bottles, sealant barrels, etc. The machine adopts microcomputer numerical control technology,...
How often is the bottle blowing machine maintained? What are the precautions for maintenance? (2)
14-09-2020
1. When the bottle blowing machine is in operation, it is necessary to pay close attention to whether the machine has abnormal noises, to find out early, and to stop it in time and deal with it early. 2. In an emergency,...
How often is the bottle blowing machine maintained? What are the precautions for maintenance? (1)
07-09-2020
Blow molding machine maintenance is to prevent the low-level failure of the blow molding machine in advance, and check and maintain the parts and components of the equipment. The common maintenance is daily maintenance, ...