Maintenance and repair blowing machine


1:bit addition without addition: the need to check seve […]

1:bit addition without addition: the need to check several cases: whether the hopper is not expected, and if it is: Sign feed is not required: Please contactor control checks whether the hoist energized state, if it is energized state, quickly check if a motor is energized and load status, because this situation is likely to be stuck in a lift with a preform (embryo), then the easiest way is to help improve artificial. If the control contacts checks hoist is not energized state, check that the electric eye detection of the preform and the reflection plate are not the same straight line.

2: feed the old card feeder tray: This situation is more difficult problem, from the point of view of experience if preform (embryo) is relatively long length cut heavy weight, then this phenomenon is relatively small.

3 :the blown bottle can not be removed from the mold. Should first mold is opened manually opening and closing the mold, if the normal operation state running empty it, if it is normal. Check your exhaust time setting, if the exhaust gas properly set, and each blowing on a long fault, then the problem is based on the exhaust valve, the exhaust valve open and the check spring seal case (which there is also a kind of fault phenomenon is relatively large exhaust sound or voice did not break the net). If you encounter a lot of mold production is normal to occasionally look at such a situation they can not die, please check whether clamping pin for some of the screws on the inside, another check clamping strength is too large, if too should follow standard readjusted.


4 :bottles always pinch the robot is not dislocated.