News -

Home / News (Page 10)

What are the characteristics of semi-automatic bottle blowing machine
20-03-2020
First, blow 0.1-12 litre PET bottles (one out of two). Second, special air storage device. Thirdly, using a two-cavity mold to blow a 600 ml bottle can produce 1,000 bottles per hour. Fourth, the advanced PLC control sys...
Analysis of blow molding methods of hollow blow molding machines
14-03-2020
Stay in the two-step blow molding machine material in the blow molding machine type WLK combined single-shaft by blow molding into particles in the range of 40 mm, follow-up time, and then use a blow molding machine to b...
Blow mould
06-03-2020
In a blow molding process, a heat pipe of molten plastic is extruded through a die. The molten plastic's heat pipe was suspended in midair before the mold was closed, and it was stretching and cooling when the pipe was i...
Essential knowledge for safe operation of automatic bottle blowing machine
28-02-2020
(1) Lubricant must be applied to each moving part before each shift is started. (Manipulator, manipulator guide, mold opening and closing guide) (2) The swing arm can be added once every day (3-4). Warm machine large cha...
3 factors to consider when buying a PET blow molding machine
22-02-2020
PET is a form of polyester that is usually extruded or molded in plastic bottles and other containers. This is a very valuable packaging material because it is both strong and lightweight. It has become a common manufact...
Blow molding
10-02-2020
In blow molding process, the hot melt plastic pipe extrusion through a die. Hot melt plastic pipe mold is closed before being suspended in midair, and it is stretched and cooled in the air when the tube. By injection mol...