1L-3L Semi-Auto Blow Moulding Machine
One with two semi-automatic blow molding machine
600-800BPH Two cavity semiautomatic bottle blow molding machine can produce two plastic bottle once. It is very mature PET bottle making machine. It is widely used to produce 100-2000ml carbonated bottle, mineral water, pesticide bottle oil bottle cosmetics, wide-mouth bottle etc.
Volume of product:0.1L-2L
Production capacity:600-800 psc/hour
Adopting double crank to adjust mould ,heavy locking mould, stable and fast ,Adopt infrared oven to heat the perform ,the perform rotated and heated equally.
The new double arm five fulcrum four rod clamping structure (patented), cross orientation, template balanced operation, chain transfer mode, the hinge components used are inlaid with high hardness alloy steel sleeve and high hardness alloy steel shaft, the clamping force, super wear-resistant, tight clamping seam and fine.
The whole machine adopts the super standard anti vibration overall structure design, in the high speed operation of the machine, the vibration to the minimum degree, to ensure that the use of parts is not due to the vibration of the machine and affect the service life.
And the whole casting machine frame to enhance the stability and the stability of the whole machine.
The use of linear guide rail moving template, remove the old bearing bracket. The friction force between the draw rod and the template is greatly reduced, and the service life of the machine is prolonged.
Double start work, using photoelectric safety protection device to prevent injury.
Energy saving design, can make you have a greater efficiency.
And put the bottle blank and special one-way one-way function, which take the bottle, put two action crisp, increasing production capacity.
Separate air control system to prevent the emission of waste gas pollution, to achieve health inspection standards.
The front and back, the left and the right direction of the machine head (stretching cylinder) are adopted in parallel regulation mode, so that the mold installation is more convenient and faster.
|Number of cavities||0.1-3L 2cavity|
|Mould plate size||490x470mm|
|Voltage standard||380v/3PH/50Hzorspecoal order|
|Total power(full loaded)||3-10KW 5-15KW|
|Blow molding machine||170*60*180cm|
|Pre - heater||150x70x140cm|
|Neck diameter range||28-100mm|